• Home

• Ribbon Anodes

• Zinc Wire

• Reroll & Strip

• Zinc Shot

• Eyelet Products

• Engineering

• Contact Us

• History

• Request Quote

Zinc Shot

Plattzinc Zinc Cut Wire Shot- Designed Specifically for Die Castings
	Plattzinc Cut Wire Shot is an efficient abrasive media produced in either 99.95% pure zinc or alloyed for your special requirements.

Applications:
Deburring and deflashing of zinc or aluminum die cast parts in both wet and dry operations. Removal of impregnated sand from sand castings.

Features:
Zinc Cut Wire Shot will not damage soft-alloy cast parts and in most cases, parts need no other cleaning prior to a plating process. Plattzinc Cut Wire Shot creates less dust than either steel or aluminum abrasives. Provides temporary galvanic protection. A thin film of zinc up to 1.3 microns is deposited onto cast parts which will temporarily protect parts from corrosion. Reusable and recyclable. Does not flash rust or red rust during storage. No premature breakdown or flaking.
Will not cause excessive wear and tear on finishing equipment.

E-mail: zincshot@plattbros.com